Needles are cemented into the conical glass luer tip of the barrel at a point corresponding to the zero graduation mark.

Needles are cemented into the glass syringe barrel at a point corresponding to the zero graduation mark. NR stands for syringes with Rheodyne specified needles.

Hamilton offer customised syringes with special needles. State the following: needle length, guage, point style, and whether electro-tapered.

Ground glass syringe barrel with a male luer taper accepts most hyperdermic needles. Use Kel-F hub needle and connectors for a tight seal.

Removable needles seat precisely to the zero mark of the syringe. Allows the use of different specification needles on the same syringe barrel. RNR stands for syringes with Rheodyne specified removable needles.

Replaceable needle; knurled hub is used on 7000 series syringes exclusively. The attachment of a spacer enables repeatable depth injections.

On/Off syringe valve with RN needle is cemented to a syringe barrel. Used for headspace, environmental sample collection and storage, pre-pressurisation of gaseous samples for GC analysis, and sample spiking.

Male luer taper with nickel-plated brass hub accepts and locks in place luer hub needles and connectors. The X-style plunger stop incorporates a 6-32 UNC female thread on the end of the stop to allow attachment to drive arm mechanisms such as on the MICROLAB 500 series diluters/dispensers.

Used in drive arm mechanisms such as on MICROLAB 4000 or PSD2. Back-bushing syringes increase plunger tip life, maintain proper plunger alignment and reduce the particles generated by plunger to glass contact.

These 60mm stroke TLL-style syringes are compatible with many liquid handling instruments, including XL-3000 modular digital syringe pump, Tecan, Rosys, Cavro IQ series sample processors and OEM liquid handling applications.

These syringes are designed specifically for the PSD3 (half height syringe pump).

1/4"-28 UNF, male fitting. Used in low volume applications where system dead volumes need to be minimised. The X-style plunger stop incorporates a 6-32 UNC female thread on the end of the stop to allow attachment to drive arm mechanisms, such as on the MICROLAB 500 series diluters/dispensers.

These 30mm stroke C-style syringes are compatible with many liquid handling instruments, including XL-3000 modular digital syringe pump, Tecan, Rosys, Cavro IQ series sample processors and OEM liquid handling applications.

TLL, TEFLON Luer Lock, male fitting with M6 x 1 female, side port. The X-style plunger stop incorporates a 6-32 UNC female thread on the end of the stop to allow attachment to drive arm mechanism, such as on the MICROLAB 500 series diluters/dispensers.

M8 x 0.75, male fitting. Used with MICROLAB 1000 plus diluter/dispenser.

M8 x 0.75 male fitting with M6 x 1 sideport. Used with MICROLAB 1000 plus diluter/dispenser.

Some replacement needles can be specified as electro-tapered. Use this style for applications such as attaching PTFE tips, or for use on on-column GC injectors.

Syringe Guide - easily installed on a syringe to prevent the plunger from bending or from being pulled out

Reproducibility (Chaney) Adapter - easily installed on a syringe for consistent, reproducible injections; also prevents plunger damage

Reinforced Plungers - Series 600, 800, 900 and 1800 syringes offer an extended barrel which prevents bent plungers